Hook-On Ceiling

Product Features

Adjacent strips interlock along their folded edges and engage with a hook-on carrier.
The connected edges form close linear joints.
Face widths of 150, 200 and 300 mm correspond to edge heights of 20, 25 and 29 mm respectively.

Material: Aluminum strip
Length: Up to 6,000 mm
Thickness increments: 0.05 mm within the thickness ranges
Panel layout: Linear strips with matching carriers

Request This Product View Specifications

Moisture resistance
Recyclable aluminum
Color retention*
Acoustic options*
Heat dissipation*
Lightweight & workable

*Color retention depends on the finish. Sound absorption requires a specified acoustic assembly; heat dissipation depends on the open or perforated layout.

Product Data

Specifications & Size Options

Technical overview
Item	Specification
Material	Aluminum strip
Length	Up to 6,000 mm
Thickness increments	0.05 mm within the thickness ranges
Panel layout	Linear strips with matching carriers

Size and configuration options
Face width (mm)	Edge height (mm)	Thickness (mm)
150	20	0.50–0.70
200	25	0.60–0.80
300	29	0.70–1.00

Dimensions are in millimeters unless another unit is shown. Final sizes, finish and matching components are confirmed on the approved product schedule.

System Detail

Construction & Installation

Hook-on strips with matching hook-on carriers

Hook-on strip assembly — numbered English component reference — Enlarge drawing & English key

Reading the Drawing

Hook-on strips engage with matching carriers and with the adjacent strip edges. The separate profile views show the carrier and interlocking panel cross-section.

Numbered Component Key

Match each number to the label below. Dimensions shown on the drawing are in millimeters unless noted.

Strip-carrier hanger
Hook-on strip carrier
M8 galvanized hanger rod
38/50 main-carrier hanger
38/50 main carrier
Profile widths: 150 / 200 / 300 / 400 mm
Hook-on strip
Galvanized hanger rod
Width

Installation Steps

Measure the finished ceiling elevation from the design drawings. Mark the level line and fix the perimeter angle along the walls.
Establish the installation direction. Drill suspension points in the structural ceiling at no more than 1,200 mm spacing and secure the galvanized hanger rods with expansion anchors.
Fit the main-carrier hangers and light-steel main carriers. Adjust their height and level, keeping the carriers parallel.
Use strip hangers to connect the hook-on strip carriers to the main carriers. Level the secondary carriers; keep them parallel to one another and perpendicular to the main carriers.
Fit the hook-on strips into the matching secondary-carrier clips, working in one direction.
Measure perimeter panels on site, cut them to fit and support their edges on the perimeter angle.
Keep hands clean during installation. Avoid sweat, oil and other contamination on the finished surface.

These system details explain the illustrated assembly. Anchor selection, structural capacity and final suspension spacing must follow the approved project drawings and local requirements. Different carrier configurations are not interchangeable.