High-Edge Clip-In Ceiling

Product Features

Raised clip-in edges conceal the carrier grid above the panel face.
Folded returns are 25 or 30 mm; square-edge and beveled-edge versions are available.
Plain and perforated faces use the corresponding concealed-grid connection.

Panel type: Clip-in aluminum tile
Edge height: 25 or 30 mm
Face: Unperforated or perforated
Thickness increments: 0.05 mm; 0.10 mm for the 600 × 2,400 mm format

Request This Product View Specifications

Moisture resistance
Recyclable aluminum
Color retention*
Acoustic options*
Heat dissipation*
Lightweight & workable

*Color retention depends on the finish. Sound absorption requires a specified acoustic assembly; heat dissipation depends on the open or perforated layout.

Product Data

Specifications & Size Options

Technical overview
Item	Specification
Panel type	Clip-in aluminum tile
Edge height	25 or 30 mm
Face	Unperforated or perforated
Thickness increments	0.05 mm; 0.10 mm for the 600 × 2,400 mm format
Aluminum grades	3003-H24 / 5052

Size and configuration options
Module (mm)	Thickness (mm)	Edge height (mm)
300 × 300	0.50–0.70	25
300 × 600	0.50–0.70	25
300 × 1,200	0.60–1.00	25
400 × 400	0.50–0.80	25
400 × 1,200	0.70–1.20	30
500 × 500	0.50–0.80	25
600 × 600	0.50–1.00	25
600 × 1,200	0.65–1.10	25
600 × 2,400 (square edge)	1.20–1.50	25

An additional 30 mm high-edge series is shown in 600 × 600, 600 × 1,200 and 300 × 1,200 mm formats. Specify this series separately from the standard edge-height table.

Dimensions are in millimeters unless another unit is shown. Final sizes, finish and matching components are confirmed on the approved product schedule.

System Detail

Construction & Installation

High-edge panels with V-type concealed carriers

High-edge concealed-grid assembly — numbered English component reference — Enlarge drawing & English key

Reading the Drawing

The raised panel edges engage with the concealed carriers. The lower drawings identify the carrier, connector and hanger.

Numbered Component Key

Match each number to the label below. Dimensions shown on the drawing are in millimeters unless noted.

High-edge carrier
M8 galvanized hanger rod
No. 50 main carrier
High-edge carrier hanger
High-edge ceiling panel
Carrier connector

Installation Steps

Components: M8 galvanized rods; light-steel main carriers; concealed-carrier hangers, carriers and connectors; high-edge panels.

Measure the finished ceiling elevation from the design drawings. Mark the level line and fix the perimeter angle along the walls.
Establish the installation direction. Drill suspension points in the structural ceiling at no more than 1,200 mm spacing and secure the galvanized hanger rods with expansion anchors.
Fit the main-carrier hangers and light-steel main carriers. Adjust their height and level, keeping the carriers parallel.
Use V-carrier hangers to connect the V-type concealed carriers to the main carriers. Level the secondary carriers; keep them parallel to one another and perpendicular to the main carriers.
Align the two clip edges of the panel with the carrier slots. Gently press the panel edges upward until the returned edges engage in the carriers.
Measure perimeter panels on site, cut them to fit and support their edges on the perimeter angle.
Keep hands clean during installation. Avoid sweat, oil and other contamination on the finished surface.

These system details explain the illustrated assembly. Anchor selection, structural capacity and final suspension spacing must follow the approved project drawings and local requirements. Different carrier configurations are not interchangeable.