C-Shaped Ceiling

Product Features

Low beveled edges form closely spaced linear joints.
Carrier teeth locate each strip; individual strips can be removed for cleaning or replacement.
Face widths are 100, 150, 200 and 300 mm, all with a 15 mm return.

Material: Aluminum strip
Length: Up to 6,000 mm
Thickness increments: 0.05 mm within the thickness ranges
Panel layout: Linear strips with matching carriers

Request This Product View Specifications

Moisture resistance
Recyclable aluminum
Color retention*
Acoustic options*
Heat dissipation*
Lightweight & workable

*Color retention depends on the finish. Sound absorption requires a specified acoustic assembly; heat dissipation depends on the open or perforated layout.

Product Data

Specifications & Size Options

Technical overview
Item	Specification
Material	Aluminum strip
Length	Up to 6,000 mm
Thickness increments	0.05 mm within the thickness ranges
Panel layout	Linear strips with matching carriers

Size and configuration options
Face width (mm)	Edge height (mm)	Thickness (mm)
100	15	0.40–0.70
150	15	0.40–0.70
200	15	0.45–0.80
300	15	0.60–0.90

Dimensions are in millimeters unless another unit is shown. Final sizes, finish and matching components are confirmed on the approved product schedule.

System Detail

Construction & Installation

C-shaped strips with 50 mm-pitch carriers

C-strip ceiling assembly — numbered English component reference — Enlarge drawing & English key

Reading the Drawing

The 50 mm-pitch secondary carriers support the C-shaped strips. Individual strips engage with the carrier clips; the section shows the concealed suspension above them.

Numbered Component Key

Match each number to the label below. Dimensions shown on the drawing are in millimeters unless noted.

Strip-carrier hanger
50 mm-pitch strip carrier
M8 galvanized hanger rod
38/50 main-carrier hanger
38/50 main carrier
C-shaped beveled strip
Galvanized hanger rod
Widths: 150 / 200 / 300 mm
Width

Installation Steps

Components: M8 galvanized hanger rods; 38/50 light-steel main carriers and hangers; strip hangers; 50 mm-pitch carriers; C-shaped strips.

Measure the finished ceiling elevation from the design drawings. Mark the level line and fix the perimeter angle along the walls.
Establish the installation direction. Drill suspension points in the structural ceiling at no more than 1,200 mm spacing and secure the galvanized hanger rods with expansion anchors.
Fit the main-carrier hangers and light-steel main carriers. Adjust their height and level, keeping the carriers parallel.
Use strip hangers to connect the 50 mm-pitch strip carriers to the main carriers. Level the secondary carriers; keep them parallel to one another and perpendicular to the main carriers.
Fit the C-shaped beveled strips into the matching secondary-carrier clips, working in one direction.
Measure perimeter panels on site, cut them to fit and support their edges on the perimeter angle.
Keep hands clean during installation. Avoid sweat, oil and other contamination on the finished surface.

These system details explain the illustrated assembly. Anchor selection, structural capacity and final suspension spacing must follow the approved project drawings and local requirements. Different carrier configurations are not interchangeable.